Written by
Elena Vasquez Appliance Care EditorPublished October 26, 2026
VERIFIED
Error code2 flashes
ApplianceIce Maker
Two blinks: what the board is telling you
When the diagnostic LED on a U-Line CLR2060 clear ice maker pulses two times, the control board has found an open thermistor. It may instead have found a temperature outside the allowed range because the unit is too warm.
Applies to: CLR2060 units built after 12/1/03.
Board: the revised control board that carries the diagnostic LED.
Series: legacy, so this is an older design.
Compare the three LED patterns
Blinks
Condition reported
1
Overflow protection circuit open; only units with a P-60 pump are checked for this
2
Open thermistor or too-warm, out-of-range reading
3
Both of the conditions above together
How to reset it
Stored codes disappear only if the board loses power for a moment. Flipping the ON/OFF/CLN switch to off has no effect on them. Should the blinking come back once power returns, the fault is still there and a technician needs to look at the unit.
Codes that share this LED
3 flashes: the board is reporting both conditions at the same time.
1 flash: only the overflow protection circuit is open.
Ice maker repair in San Francisco and the Bay Area
Owners of a CLR2060 around San Francisco and the Bay Area can reach U-Line ice maker repair by phone at (415) 329-7078. Note that the LED blinks twice, read the model number off the unit, and mention whether you cut power to the board.
Model compatibility: U-Line reuses codes across series and model years, so 2 flashes may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Two LED flashes report an open thermistor or a reading that is out of range because it is too warm.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your U-Line appliance?
Book a specialist visit for a clear estimate and approval before any repair.
You submit a request with your appliance model and symptom, we confirm an appointment window, and a technician performs an on-site diagnosis. You then receive a clear estimate and decide whether to proceed before any repair begins.
Yes. We provide an upfront estimate after diagnosis. No parts are ordered or installed until you approve the work, so there are no surprise charges.
Replacement parts are selected for the exact model and confirmed with you before ordering or installation.
Service areas are listed on the Locations page. Contact us with your ZIP code to confirm current coverage for your address.
Ready to get your U-Line appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
